Week 14 : The D-day

This week is the presentation week of my remote control helicopter after all had been done. Even i only can show the prototype in simulation but i wish to continue this project until it's can function like i want in the future. In shaa Allah.. :) 

I think this is the opportunity for me to thanks for  my Final Year Project Advisor Dr. Zulkhairi from Electronic Engineering Department University of Kuala Lumpur British Malaysian Institute for his support and advise in making my project.

THANK YOU.. :)

Week 13

In this week, i spent a lot of my time preparing my poster for the presentation next week. this is my poster. :)

Week 11 and 12

After my circuit is succeed using breadboard, on week 11 i try to sketch the connection all of the component before transfer that circuit to the PCB board. Here is my sketch and on week 12, after all of this thing is done, i soldering the component, test and make troubleshooting to the circuit.

Week 9 and 10

After my experiment was finished, in this two weeks, i went to Jalan Pasar to buy a few component that i use in this circuit such as pic16f877a, resonator ceramic (as oscilator), resistor, capacitor and etc. After i got all component that needed in this circuit, i continued my work with construct the circuit and test.

Week 8

This week, i met madam Norhayati again for making some testing to original remote control. The video below was our experiment.. :)

Week 7

After making a more and more in programming but the result was still failed.. this week i met madam Norhayati, technician, to get a bit of advice about my problems. And she gave me an advice to make re-study about the original remote control again.. i'm really appreciated it. :)

Week 6

When i am succeed do in the basic program, i move on the second step that's i tried to program the motor like i do in the previous week. i try n try.. but i failed.. i'm so disappointed. :'(